Updating MLO and other files on the FAT partitionFirst make sure you can mount the FAT partition from Linux. You will need to add the line: /dev/mmcblk0p1 /media/FAT auto defaults,sync,noauto 0 0 to /etc/fstab on the E100. Also make sure the directory /media/FAT exists. Then run: # mount /media/FAT Using files from E1XX Files copy the file you wish to update over the existing file on the micro SD card. It is important not to remove the copy of MLO, just copy the new MLO over it. The boot loader code is very fussy about the disk geometry and that MLO was the first file written to the card. Overwriting it leaves it in the same place so it will still boot. 注:Updating MLO and other files on the FAT partition(英文原文出处,以上翻译整理仅供参考! email: support@microembedded.com) |